EXPLORER BRIDGE

PLEASE READ BEFORE ORDERING - THIS IS A PRE-ORDER
This is the kit of the diorama inspired by the bridge of the USS Enterprise NCC-1701-D seen in TNG

Available in three different variants:
Early Explorer, inspired by the bridge appearence during the first season,
Next Explorer, inspired the bridge design during seasons 3 to 7,
Last Explorer, inspired by the darker version of the Generations bridge.

Available in two different scales and as a DIY Kit or as a Complete Diorama

The dioramas have a hole in the main viewscreen to look inside!

1/38 scale:
Lenght: 40 cm
Complete of roof and lights

The DIY kits includes:
the parts 3D printed in black PLA,
the computer panels printed on adhesive paper,
LEDs, resistors, switches and battery holders for the lighting
The DIY kit takes approximately 6 weeks to be printed and prepared

The Complete Diorama is already assembled and wired, ready for display!
The Complete Diorama takes approximately 12-16 weeks to be printed and prepared

1/76 scale:
Lenght: 20 cm
Plastic transparent cover to close the top of the diorama
Roof and electronics are included with the 1/38 scale version only

The DIY kits includes:
the parts 3D printed in black PLA,
the computer panels printed on adhesive paper.
The DIY kit takes approximately 4 weeks to be printed and prepared

The Complete Diorama is already assembled, ready for display!
The Complete Diorama takes approximately 8-10 weeks to be printed and prepared